Atlantic Seaboard · Camps Bay
Television repair in Camps Bay
Camps Bay sits in the full force of the Atlantic, and salt reaches the inside of a television long before anyone notices it on the outside. Most of our work here is on large wall-mounted screens, repaired in the house.

Two things make a Camps Bay call-out different from one in the southern suburbs. The first is the air. Salt spray comes off the Atlantic and settles on everything, and a television is not a sealed box — it breathes through vents at the back and the top, and what is in the room eventually gets inside the cabinet. The second is the hardware. Screens here are large, often 65 inches and up, frequently mounted high in a double-volume room, and sometimes on a split-level that makes carrying them anywhere a two-person operation with a real risk of a cracked panel.
Both of those push us towards repairing in the house rather than removing the set. Power supply boards, backlight strips, mainboard and input faults, and software problems are all workshop-grade jobs that a technician can do properly on site with the right kit. We say up front which faults are the exceptions.
Salt gets inside long before you can see it
Corrosion does not announce itself. It starts as a dull film on solder joints and connector pins, and the first symptom is usually intermittent rather than dead: an HDMI input that works if you jiggle the cable, a set that switches on some days and not others, sound that cuts out and comes back. Left alone, the affected joint eventually opens completely and the fault stops being intermittent.
Knowing the difference is worth money. An intermittent fault caught early is often a clean-and-reflow job on a handful of joints. The same connector six months later can mean replacing the whole port assembly, and on some chassis that means the mainboard with it.
- An input that only works when the cable is pushed or wiggled
- A set that starts on the second or third press of the remote
- Sound that drops out for a second and comes back
- Dull or powdery residue on the connectors at the back of the set
- A wall bracket showing rust streaks where it meets the wall
Screens too big to carry down a staircase
A 75-inch television weighs less than people expect and is far more fragile than they expect. The panel is glass and it flexes. Carried flat, or gripped by one person at the middle of the frame, it can crack without ever being dropped, and a cracked panel is the one fault we cannot repair economically. So we bring what we need to work where the set already is: mats, the tools for the bracket, and a second pair of hands where the mount is high or the ground under the house is stepped.
Camps Bay driveways are steep and many houses run over three or four levels, which mostly affects how long the first ten minutes take. Tell us which level the set is on when you book, and whether a vehicle can stand off the street, and we will send the right number of people.
While the set is off the bracket
We check the mount and the wall behind it before the television goes back up. Brackets on the seaboard rust from the wall side outwards, so a fixing that looks sound from the front can be perished where it counts. It costs nothing to look while we are already there.
Patio and outdoor viewing areas
A lot of homes here have a screen in a covered outdoor area. Unless it was sold specifically as an outdoor television, it is an indoor set living outdoors and it ages accordingly. Condensation forms inside the cabinet overnight, insects get in through the vents, and a few hours of direct afternoon sun pushes the internal temperature well past what the design allows. The failures that follow are real ones, usually power supply or backlight, and they are repairable — but they come round again unless something changes about where the set lives.
If you are replacing a set that has died out there, it is worth a conversation about position and shelter before the new one goes up. Our page on backlight repair covers the fault that heat causes most often.
When the television is fine and the room still shows nothing
Multi-room installations are common in the larger houses, and they add failure points that have nothing to do with the screen. A long HDMI run behind a wall, a splitter in a cupboard, a source device with a handshake problem — any of those produce a blank screen in one room while the rest of the house carries on. Before quoting for a repair we establish whether the set itself is at fault by testing it with a known-good source at the panel. It is a five-minute test that regularly saves a customer the cost of a repair they never needed. Network and software faults are covered on our smart TV repair page.
How we price the work
The technician diagnoses first and quotes second, with the set open and the actual failure identified. If the panel is cracked, or the repair costs more than the television is worth, we tell you that instead of quoting for it. Repair work carries a six-month guarantee against the same fault returning, and we work on Samsung, LG, Hisense, Sony, Panasonic, Sinotec, TCL, Toshiba, JVC, Skyworth and Telefunken.
Satellite work in Camps Bay
Corrosion at the LNB and the connectors is the usual reason a dish up here loses signal gradually over a season rather than all at once. That is a separate job from a television repair — see DStv installation and repairs in Camps Bay.
Questions we get asked in Camps Bay
Do I need to take the television off the wall before you arrive?
Can salt damage be repaired, or does the whole board have to be replaced?
Our patio television died after one summer. Will a replacement do the same?
Is a 75-inch screen worth repairing?
Can you work on a set mounted high on a double-volume wall?
Get it sorted
Book a technician
Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.
218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za