DStv · Cape Town

DStv in complexes, flats and apartment blocks

In a block, half the installation belongs to somebody else. Knowing which half is yours, and which half is the building's, is the difference between a ten-minute fix and a month of phone calls.

Communal satellite dishes on the roof of a Cape Town apartment block

A large share of our satellite work is in sectional title. Cape Town has a great deal of it — the Atlantic Seaboard strip, the City Bowl fringe, Century City, and the newer complexes spreading through the Northern Suburbs and out along the West Coast. The technical work is not harder than in a house. What is different is that the equipment does not all belong to you, and the rules about what may be fitted to the outside of the building are not yours to set.

Work out which system you are actually on

Before anything else, establish how satellite signal reaches your unit. There are three common arrangements and they lead to completely different jobs.

A communal dish feeding every unit

One or more dishes on the roof, feeding a distribution system that runs down the risers and terminates at a wall point in each flat. You plug your decoder into that point. You own the decoder and the flex; the building owns everything from the wall backwards. This is the most common arrangement in older blocks and in almost all managed developments.

Your own dish on a balcony, wall or roof position

Some blocks allow individual dishes, either in designated positions on the roof or on a balcony where the line of sight allows it. The dish is yours, and so is the maintenance of it, but the fixing point is usually common property — which is why permission matters even when the equipment is your own.

A shared dish serving a handful of units

Small complexes of six or eight units often have one dish shared between them with a splitter or switch in a cupboard, installed years ago by whoever was there first. Nobody is quite sure who owns it. These are the installations where we most often find the original fault, because no one has maintained the shared part since the day it went up.

Why the fault in a block is often not your dish

This is the single most useful thing we can tell somebody living in a flat. When the picture goes, the assumption is that the dish needs realigning. In a building with a communal system, the dish is very rarely the problem — it is bolted to a roof, serving dozens of units, and if it had moved, the whole block would be dark at the same moment.

What actually fails is the distribution between that dish and your lounge. There is a great deal of it: splitters and switches in service cupboards, amplifiers that have quietly died, runs of cable that were installed when the building went up and have never been touched, and connectors in a riser that has been damp for a decade. One corroded joint in a cupboard on the third floor takes out the flats above it and nothing else.

Two questions worth asking before you book anyone

The answers narrow the fault down before a technician sets foot in the building.

  • Does your immediate neighbour have a picture right now? If several units are affected, it is a building problem and the body corporate must act.
  • Does it fail only in rain and wind, and recover afterwards? DStv attributes its E48-32 code to stormy weather and rain, which is a different matter from a system that never locks on.

If only your flat is affected, the fault is likely on your side — the wall point, the flex from it, the connector on the back of the decoder, or the decoder itself. That is straightforward work and we can do it. If the whole stack is affected, the honest answer is that the building has a problem, and we will say so rather than charge you for standing in your lounge confirming it. Our page on DStv signal problems sets out the same diagnosis for a freestanding house.

The Smart LNB and multiple unit dwellings

This one matters, because it is stated by MultiChoice and it is regularly ignored. The DStv Smart LNB — which combines the features of a DStv Switch into a single UniCable LNB and offers a single cable solution for distributing multiple satellite signals — is recommended for all DStv Explora and most XtraView installations in single-unit dwellings.

MultiChoice states it is not suitable for Multiple Unit Dwellings, and that means complexes and apartments. So if you live in a block and somebody has quoted you for a Smart LNB, it is worth asking why. The equipment that serves a building is a different class of thing, designed to distribute signal to many units from a shared head end. Our Smart LNB page sets out both models MultiChoice names and what each carries, so you can see exactly what the recommendation covers.

None of that stops a Smart LNB being right for the freestanding house you might move to later. It simply is not the answer for a flat, and knowing that saves you paying for hardware that does not address the problem.

What may and may not go on the outside of the building

The external walls, the roof, the risers and usually the balcony railings are common property. That is not a technicality invented to be annoying; it is how sectional title works, and it means the body corporate decides what is fixed to them.

  • Most schemes have a rule about dishes on facades and balconies, and many prohibit them outright on street-facing elevations
  • Where dishes are allowed, there is often a designated roof position rather than a free choice
  • Drilling through an external wall or a waterproofed roof membrane needs written permission, and for good reason — a hole in a flat roof is somebody's ceiling
  • Cable is normally required to run in the existing risers or ducts rather than down the outside of the building
  • Some older buildings, particularly in the City Bowl and along the Atlantic Seaboard, sit under heritage controls that restrict what may appear on a street elevation at all

We will not fix anything to common property on your word alone. If the trustees or the managing agent give consent, we do the work; if they will not, we look at what can be done inside your unit instead. That is not us being difficult — it is the only way you do not end up removing an installation at your own expense six months later.

Dealing with trustees and managing agents

A little preparation makes this much easier. Ask for consent in writing, and make it specific: what is being fitted, where, how the cable will run, and who is doing the work. A vague request gets a vague answer or none at all. If your building keeps a list of contractors it will admit, ask what the requirements are — many want a contractor signed in at the gate, some restrict working hours, and roof access is often controlled by a single key held by the caretaker.

Tell us all of that when you book. We work in blocks constantly and none of it is a surprise; what causes wasted visits is arriving to find the roof locked and nobody with the key on site. Where a body corporate is dealing with a communal system that has degraded across the whole building, we are happy to talk to the trustees directly rather than through a resident, because the scope of that work is a building decision and not a flat-by-flat one.

When a block has no communal system at all

Some smaller complexes never had one, and every unit fends for itself. Where the scheme permits individual dishes, the job becomes an ordinary installation with an unusual constraint: the line of sight. In dense strips like Sea Point, the obstruction is almost always the neighbouring block rather than a tree, and a position that works on the fourth floor is useless on the second. In canal-side developments such as Century City, the buildings sit close enough together that a viable position may not exist on your elevation at all.

We check that before anyone commits to anything. If there is no line of sight from a position the scheme will allow, we tell you, and you have saved the cost of an installation that was never going to work. Where a position does exist, the mounting and the sealing matter more than usual — wind funnels between buildings, and a bracket into face brick on an exposed elevation is a serious piece of work. The connector standard we use for those is described on our cabling and TV points page.

Questions we get asked

Nobody in my block has a picture. Is that something I should be paying to fix?
Almost certainly not on your own. If several units are affected at once, the fault is in the building's shared distribution, which is common property and the body corporate's responsibility. Report it to the trustees or the managing agent. Paying a technician to attend your flat will only confirm what the neighbours already told you.
Am I allowed to put up my own dish on my balcony?
That depends entirely on your scheme's rules, and many prohibit it on street-facing elevations. The balcony structure is usually common property even though you have exclusive use of it, so you need the body corporate's consent in writing before anything is fixed to it.
Why is a Smart LNB not used in apartment blocks?
MultiChoice states the Smart LNB is not suitable for Multiple Unit Dwellings, which covers complexes and apartments. It is recommended for single-unit dwellings. If you have been quoted for one in a block, ask what problem it is meant to solve before agreeing to it.
Can you work on the building's communal system?
We can, but only with the body corporate or managing agent instructing it. The shared equipment is not the property of an individual owner, so an individual resident cannot instruct work on it. Where trustees want the whole system looked at rather than one flat, we would rather deal with them directly.
My unit has a wall point but nothing comes out of it. What now?
It usually means the run to your unit has failed somewhere between the riser and your wall, or the point itself was disconnected during past work in the building. We can test from your side to establish whether signal reaches the plate. If it does not, the next step involves the building rather than your flat.
The building's rules say no dishes. Is there anything I can do?
Sometimes. If the block has a communal system, connecting to that is the intended route and no dish is needed. If it has none and the rules genuinely forbid one, the honest answer is that satellite may not be possible in that unit, and it is better to know that before spending money on equipment.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za