DStv · Cape Town

Extra viewing points around the house

Multiroom is a cabling job before it is anything else. Decide where the pictures need to be, work out how the cable reaches those rooms, and the rest follows.

Coaxial cable being run through a roof space above a ceiling

Households ask for this for ordinary reasons. Somebody wants the rugby in the lounge and somebody else wants anything but the rugby. A bedridden parent has moved into the spare room. The braai area has a screen under the patio roof and nothing feeding it. A cottage at the back of the property is being let out. In every case the question is the same: how do we get a working point into that room without making a mess of the house.

Start with where the pictures need to be

We ask for the full list first, including the rooms you are not doing yet. A point you might want in the study next year is almost free while the roof space is open and the tools are out; the same point added on its own in eighteen months is a separate job with a separate call-out. Planning for four points and installing two is a sensible way to do this.

It also changes the equipment decision. How many feeds an installation has to carry is what determines the LNB, and getting that right at the start avoids replacing it later. On a freestanding house that usually means a Smart LNB, which MultiChoice recommends for single-unit dwellings precisely because it distributes multiple satellite signals down a single cable rather than needing a run per feed.

How the cable gets from the dish to the far bedroom

Cape Town housing stock gives us three broad situations, and they are not equally easy.

A pitched roof with an accessible roof space

The best case, and the most common. Cable runs across the roof space and drops down internal walls to each point. Nothing is visible except the wall plate. Older tiled houses in the Southern Suburbs and the Northern Suburbs are usually this.

A flat roof or a concrete slab

No usable void, so the route is along bulkheads, inside cupboards, through existing chases where they exist, or externally in trunking that follows a line the eye already accepts. It takes longer and the result depends on the installer caring what it looks like.

Double storey with rooms below

The slab between floors is the obstacle. There is usually a route down a service duct, a corner of a cupboard or an external wall, but it has to be found rather than assumed. This is the case where we most often present two options — the quick one and the neat one — and let you choose.

Whichever route we use, the materials matter as much as the path. Quality of cable, how the ends are made off and how the wall plate is fitted decide whether the point still works in five years, and we have written about that in detail on cabling and TV points.

Outbuildings, cottages and the patio

Anything outside the main building is a different standard of work. The cable leaves the protection of the house, so it needs to be rated for it, supported so it is not hanging in the wind, and every joint sealed. Properties in Constantia and similar low-density areas often have a main house, a cottage and a garage in three directions, which turns a simple job into a proper cabling exercise with long runs and several external entries.

Patios are their own problem. A screen under a patio roof is exposed to more damp and more temperature swing than anything indoors, and the wall point behind it suffers accordingly. We fit those with the same care as an external run rather than treating them as an indoor point that happens to be outside.

One thing worth knowing before you plan

How many decoders you run and how they are linked on your subscription is a MultiChoice matter, and it is worth settling with them before the cabling is designed. We build the installation to carry what you tell us you want to run.

One practical note about wall plates in bedrooms: think about where the bed and the cupboards actually are, not where the television is standing today. We have moved a good number of points that were fitted behind a wardrobe by somebody who never asked. A plate that ends up in the wrong place is a small mistake that irritates for years.

The same goes for the height. A point at skirting level suits a set on a stand; a set going onto a wall bracket wants the point behind the screen so nothing dangles below it. Tell us which you are planning and the plate goes in the right place the first time. If the television is being mounted at the same time, we would rather do both in one visit than fit a point and then move it.

What multiroom does not fix

It is worth being clear about this, because it saves disappointment. Extra points multiply an existing weakness rather than curing it. If the dish is marginal, four points will be marginal in four rooms. If a connector outside is corroded and dropping the signal in wind, adding a bedroom point does not change that — it just gives you a second screen showing the same interruption.

So on an existing installation we look at the outside first. If something is wrong at the dish or in the run from it, that gets sorted before we add anything, and we will say so up front. Signal problems covers how we work out where a fault actually sits, and if the aim of the dish is the issue, dish alignment is the relevant page.

How a multiroom job usually runs

  1. Walk the house

    Every room on the list, plus the roof space, plus the dish. We are looking for routes and for anything already wrong.

  2. Agree the routes and the points

    You see where the cable will go and where each plate will sit before anything is drilled. Changing your mind at this stage is free.

  3. Sort the dish end

    LNB, connections and anything that needs correcting outside, because the rest of the work depends on it.

  4. Run, terminate and plate

    Cable pulled, ends made off, plates fitted square to the wall. We clean up as we go rather than at the end.

  5. Test every point on a decoder

    Not a meter reading at the wall and a promise. An actual decoder at each point, showing an actual picture, before we leave.

Questions we get asked

Is there a limit to how many points I can add?
There is, and it is set by the equipment feeding the installation rather than by the dish. The LNB models MultiChoice names carry a fixed number of user bands and outputs, and the number of points follows from that. We work it out from your list of rooms before quoting.
Can you add points without lifting the floors or chasing walls?
In most houses, yes. If there is an accessible roof space we run above the ceiling and drop down internal walls, which leaves nothing visible but the wall plate. Where there is no void we use bulkheads, cupboards or neat external trunking, and we show you the route before we start.
Should I cable rooms I am not using yet?
It is usually worth it. Adding a spare run while the roof space is already open costs very little extra, and it saves a whole separate visit later. We often install two points and leave cable coiled and capped for two more.
Can a point go outside, under a patio or braai roof?
Yes, and it is a popular request. An outdoor position sees more damp and bigger temperature swings than anything indoors, so we fit the point and seal the connection to an external standard rather than treating it as an indoor point that happens to be outside.
The lounge signal already breaks up sometimes. Should I add rooms anyway?
Fix the existing problem first. Extra points share whatever the installation already has, so a weakness at the dish or in the main run will show up in every new room as well. We would rather sort that out and then add points than hand you the same fault three times over.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za