Cape Flats · Bishop Lavis

Television repair in Bishop Lavis

Most of what we do in Bishop Lavis is repair rather than replacement. Sets that shut themselves down after twenty minutes, inputs that have stopped responding, and screens that have taken a knock.

Technician removing the back cover from a flat-screen television

Bishop Lavis sits on open ground towards the airport side of the flats, with single-storey houses and semis on compact plots. Roof access is simple and there is nothing complicated about getting to a television here. What the location does contribute is wind and dust, and dust matters more to a set than most people expect it to.

Dust, heat and sets that switch themselves off

A flat-screen television cools itself through vents, usually a row of slots along the top of the back panel and another set underneath. Air moves through, across the power board and the main board, and out again. In a dusty environment that airflow gradually silts up, and components designed to run warm start running hot instead.

The symptom is a set that works perfectly for fifteen or twenty minutes and then shuts down, drops to standby, or restarts itself. People read that as the television dying. More often it is thermal protection doing precisely what it was built to do. Cleaning it out properly, checking what has been cooked in the meantime and putting it back together is an ordinary job.

A related one worth knowing: a set pushed hard against a wall, or built into a cabinet with no clearance behind it, will do exactly the same thing in a spotless house. If yours lives in a unit, leave it a gap.

The faults that look worse than they are

  • A remote that has stopped working. Point a phone camera at the front of it and press a button. Most phone cameras show the infrared LED as a faint flicker on screen. If it flickers, the remote is fine and the receiver on the television is the problem.
  • No picture on one input. Change the cable first, then try a different HDMI socket. Ports do fail, but cables fail more often and cost nothing to rule out.
  • Sound with no picture. Far more often the backlight than the panel, which means a repair rather than a replacement.
  • Colours that have gone strange. Frequently a settings change or a loose ribbon connection rather than a dead panel.
  • A set stuck on the maker's logo. Software, and often recoverable — see smart TV repairs for what that involves.

When the screen itself is broken

A cracked panel is different from everything else on this page. There is no repair to a cracked panel — the glass and the layers behind it are one bonded assembly, and the only fix is to fit a new one. On larger, newer sets that is sometimes worth doing. On smaller or older televisions the panel is most of what the set is worth, and we will tell you so instead of quoting for it.

How to tell a cracked panel from a board fault

Look for a spider-web pattern spreading from one point, a bright or black vertical band, or an image that is correct on one part of the screen and scrambled on another. A board fault usually affects the whole picture evenly. If you are not sure, send us a photograph of the screen while it is switched on, before you book anything.

If it does come to a new panel, that work is set out on our TV screen replacement page, including what can and cannot be sourced.

When a set has been opened before

Repair-led areas attract repair-led shortcuts, and we open a fair number of televisions somebody has already been inside. Sometimes that is decent work. Often it is not: a capacitor of the wrong value, a bridged track, insulation tape where a screw belongs, or a board swapped rather than repaired that never quite worked properly afterwards.

None of that means we cannot help, but it does change how we approach the diagnosis. We look for what was done before we look for what failed, because on those sets the two are frequently the same thing. Tell us up front if the television has been worked on. It is not a confession, it is useful information, and leaving it out only costs you time on the day.

What we bring to the house

The point of an on-site repair is that the television stays where it is. The technician arrives with test equipment, soldering gear and the common failure parts for the sizes and brands we see most often, which covers a good proportion of jobs in a single visit. Where a part has to be ordered, or the fault is deeper than a house call allows, the set comes to the workshop — and you are told that at the point of diagnosis rather than afterwards. What we repair is covered for six months against the same fault coming back.

Where a part has to come from a supplier, we would rather leave the television with you and fit it on a second visit than take a working set away and sit on it. That is not always possible, because some jobs need the bench either way, but it is the default where the set is still usable in the meantime.

Questions we get asked in Bishop Lavis

The remote has stopped working. Is that the remote or the TV?
Point a phone camera at the end of the remote and press a button. If you see a faint flicker on the phone screen, the remote is transmitting and the receiver on the television is at fault. If you see nothing, start with batteries, then the remote itself.
My TV switches itself off after twenty minutes. What causes that?
Nearly always heat. Either the cooling vents have silted up with dust, or the set has no clearance behind it, and thermal protection is shutting it down. It is a routine repair, and worth doing before the heat damages something permanently.
There is dust inside the screen. Can you clean it?
Dust behind the glass itself is a panel matter and generally not worth opening a set for. Dust in the vents, on the boards and around the fan is different, and clearing that out is part of a normal service when a set is in for a heat-related fault.
The screen is cracked. Can it be replaced?
Physically, yes, but the panel is the most expensive part of a television. On a large, fairly new set it can make sense. On a smaller or older one it almost never does, and we would rather tell you that than take the job.
Do you install OpenView as well as repairing televisions?
Yes, it is the other half of what we do. OpenView has no monthly subscription once you own the equipment, and the OV512 decoder can usually run off an existing dish that points north-east, which keeps the setup cost down.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za