Cape Flats · Mitchells Plain

DStv installation, realignment and repairs in Mitchells Plain

Mitchells Plain takes wind straight off the bay with sand in it, and that is hard on the half of a satellite installation that lives outdoors. Most of what we do here is either putting one in or putting an old one right.

Satellite dish and LNB arm on the wall of a single-storey house

This is a very large suburb of mostly single-storey housing laid out in distinct sub-areas, which makes the physical side of the work straightforward. Roof access is simple, sight lines are clear in most streets, and the usual obstruction is a neighbour's roof rather than a tree or a block of flats. What is not straightforward is the weather the installation has to live through.

Sand-laden wind off the bay

Wind on its own moves things. Wind carrying sand also wears them. The place it shows first is the ends of the cable: a connector that was hand-tightened and not properly sealed lets grit and moisture past together, and the copper underneath corrodes quietly for a year before the picture starts breaking up. Cable that crosses a roof edge or hangs in an open span gets sanded where it moves.

None of that needs unusual parts to put right. It needs connectors made off properly and sealed, cable clipped so it cannot move, and the entry through the wall sealed against driven rain. That standard is set out on our cabling and TV points page, and it is most of what separates an installation that lasts in this suburb from one that does not.

Why realignment is the call we take most here

Exposure does the rest of the damage. A dish on an exposed wall here spends every summer being pushed at, and fixings give up gradually rather than suddenly. The result is an installation that loses tolerance a season at a time: fine in still weather, patchy in wind, then off in rain that would not have bothered it three years ago.

DStv lists E48 as searching for signal and E48-32 as its weather variant, which is a genuinely useful distinction to hold on to. A decoder showing a weather code in the middle of a front is telling you what you can already see out of the window. A decoder that now does it in light rain is telling you that something outside has moved or corroded. Signal problems covers the codes, and dish alignment covers what a realignment actually involves once we are there.

Single-storey roofs, and what that changes

Low roofs give us more choice about where the dish goes, and the choice is worth using. A dish at head height on a side wall is easy to fit and just as easy for a ladder, a washing line or a stray football to interfere with. Higher up, on a wall that does not face the prevailing wind, it gets left alone for years.

The limit on that choice is the view to the north-east, which shortlists the positions before anything else does. Our dish installation page explains how a position is settled and what the mounting has to do once it is chosen. Easy roof access also means the cable route is usually simple here - across the roof space, down inside a wall, out at a plate - rather than the bulkhead-and-cupboard exercise a flat roof turns into.

What an extra decoder asks of an older installation

Households here often run more than one decoder, and the second or third one usually arrives years after the installation went up. That is fine as far as the cable in the wall is concerned. What has to be checked is the equipment on the dish, because the number of feeds an installation can deliver is decided out there and not behind the television.

So we survey before quoting an extra point rather than after. If the installation has room in it, the work is a run of cable and a new point. If it is already at its limit, the part on the arm has to change as well, and you should know that before anybody starts. Multiroom installation sets out how several points get planned together.

OpenView where nobody wants a monthly bill

We are asked about OpenView here more than in most suburbs, and it is a fair question rather than a step down. OpenView is free-to-air: no monthly subscription, so once the equipment is paid for the service itself costs nothing. It uses the OV512 decoder and carries over 20 TV and radio channels, SABC channels and e.tv among them.

The part that matters for a household that already has a dish is the direction. OpenView also works off a dish pointing north-east, so where a DStv dish is up and the subscription has lapsed, it can often be reused rather than replaced. We would not tell you it stands in for a DStv subscription, but for a household that wants television without a monthly bill it does the job. OpenView installation in Mitchells Plain sets out what is involved.

Worth checking before you phone anybody

Two minutes inside the house often tells us more than a description of the picture does.

  • Whether every decoder in the house is affected or only one of them
  • Whether the fault follows the weather, the time of day, or nothing at all
  • What the screen says exactly, including any characters after a dash
  • Whether the cable behind the decoder is finger-tight or loose

Questions we get asked in Mitchells Plain

Can the dish be moved to the back of the house to get it out of the wind?
Sometimes, but the view to the north-east decides it rather than the wind. If a sheltered position still has a clear line of sight, we will happily use it. If it does not, we would rather mount properly on the exposed side than put a dish somewhere it cannot see the satellite.
Does the sand in the air really affect the installation?
It affects the ends and the edges. Grit works into any connector that was not sealed, and it wears cable where it moves against a roof edge or a loose clip. The dish itself is a reflector and is largely unbothered - it is the connections that suffer.
We stopped our DStv subscription. Can the dish still be used for something?
Often it can. OpenView uses a dish pointing north-east as well, so an existing dish in reasonable condition can frequently be reused with an OV512 decoder. We check the dish, the mounting and the cable first, because reusing a dish that has corroded through helps nobody.
The decoder shows E48-32. Do we need someone to come out?
Not necessarily. E48-32 is DStv's weather code, and DStv's own advice is to check that the cables from the dish are connected properly to the decoder, then switch the decoder off at the wall plug for at least ten seconds before switching it on again. If it clears when the weather clears, watch it. If it now happens in weather that never used to trouble it, something outside has changed.
If we only add one more point, which room is the sensible one?
Whichever room people actually sit in second, which is usually the main bedroom. The more useful question is where the cable can reach cleanly - a point in a room the run already passes is far less work than one in the far corner of the house.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za