West Coast & Blaauwberg · Parklands

DStv installation and repairs in Parklands townhouses and complexes

Almost every property in Parklands sits under a body corporate or homeowners' association with rules about what may be fixed to the outside of the building. Here, the approved position usually decides the installation before any technical question does.

Satellite dish fitted low on the side elevation of a townhouse in a complex

Parklands is newer, denser and more uniform than most of the suburbs we work in. Townhouses and cluster developments sit close together, roofs are at much the same height, and the estates were built with rules already written. None of that makes the technical work harder. What it does is add a step at the front of every job, and skipping that step is how people end up paying to take an installation down again.

Permission comes before position

The external walls, the roof and the elevations facing the street are governed by the scheme, not by the owner of the unit. In Parklands that is close to universal, and the rules are often more specific than in older suburbs: a designated position, a limit on what may be visible from the street, sometimes a colour or a size restriction, and usually a requirement that a contractor is signed in.

Ask for consent in writing and make the request specific, naming what is being fitted, where it goes and how the cable will run. A vague request gets a vague answer or none at all. Our page on DStv in complexes and apartments sets out how that process works and what trustees and managing agents usually want to see.

We will not fix anything to common property on a resident's word alone. That is not obstruction for its own sake. It is the only way you do not remove a perfectly good installation at your own cost six months later.

Finding a position the estate will accept

Parklands has an advantage that the older suburbs do not: there is very little to block the sky. The roofs are close together but they are much the same height, and there are few mature trees. In practice, several positions on a typical unit will see the north-east cleanly, which means we can usually work within the rules rather than against them.

  • A side or rear elevation, out of sight from the street, which satisfies most schemes' aesthetic rules
  • The shortest arm that keeps the line of sight clear, because a long arm gives the wind leverage and is more visible
  • A fixing into solid material rather than plaster over hollow block or a fascia board
  • A position that avoids drilling through a waterproofed roof membrane or a shared structure
  • A route for the cable that already exists, before anyone proposes making a new one

Where the unit above or beside you sits slightly higher, the position moves rather than the aim. The general standard for mounting and fixing is on our dish installation page.

Cable routing when the wall is shared

This is the part of a Parklands job that takes the thought. A townhouse in a terrace shares a wall with the unit next door, which is not somewhere to be drilling, and the units are close enough that a run down an external wall is visible from a neighbour's window rather than only from your own.

Where the developer left conduit or a ceiling void, we use it. Where nothing exists, the route is usually through the roof space and down an internal wall, terminated on a proper wall plate rather than a cable pushed through a hole in the skirting. It is slower than running trunking down the outside and it is what keeps the installation within the rules. Our page on cabling and TV points covers how the runs and points are done, and if you are adding a second decoder rather than a second television, XtraView installation deals with what the second point has to carry.

One quirk of newer developments is worth mentioning. The satellite point the developer fitted was placed for a lounge layout that many owners do not end up using, so the decoder sits across the room from the plate on a long trailing flex, or the television has been mounted on a different wall entirely. Moving the point is usually a short run through the ceiling rather than a new cable from the dish, and it is worth doing properly; multiroom installation covers what is involved when you want more than one.

Movement rather than corrosion is what fails here

Parklands is inland of the coast, so the salt load is lower than it is a few kilometres west and corrosion is a slower problem. The wind is not. The failure mode we see most here is movement rather than rust: fixings that were adequate on the day, working loose over a couple of seasons until the picture starts breaking up whenever the south-easter blows.

The pattern is easy to recognise. Signal that fails while it is blowing and is fine an hour later is a mounting that moves, not a component that has died, and realigning it without dealing with the fixings buys a few months at most. Dish alignment explains how we tell those apart. Nearer the sea, in Bloubergstrand, corrosion arrives alongside the wind and the specification changes with it.

From the ground you can usually see whether that is what is happening. Look for movement in the arm when a gust comes through, cable ties that have perished on a run clipped to a fascia, and rust bleeding down the wall from under the bracket. Any of those means the mounting needs attention before the aim does.

Questions we get asked in Parklands

Do we need written permission before a dish goes up in a Parklands complex?
In almost every scheme here, yes. The wall or roof it is fixed to is common property even though the unit is yours. Get it in writing and be specific about the position and the cable route, because a general approval tends to be disputed later by whoever did not read it.
Our rules say nothing may be visible from the street. Where does that leave a dish?
Usually on a side or rear elevation, and in Parklands that generally works. The roofs are close together but similar in height and there are few big trees, so there is normally more than one position with a clear view to the north-east. We check the alternatives before asking the trustees for anything.
Can the cable run through the wall we share with the neighbouring unit?
No, and we would not propose it. A party wall is shared structure. The route we look for is through the roof space and down an internal wall, or through whatever conduit the developer left, terminating on a wall plate inside the unit.
The rules talk about dishes but say nothing about cabling. Does that mean we can run it where we like?
No. Cable clipped to an external wall is still something fixed to common property, and in a complex this dense it is visible from a neighbour's window rather than only from your own. We route through the roof space and internal walls wherever a route exists, which keeps the installation inside the rules and looks better anyway.
Our unit is mid-terrace with no easy roof access. How does that work?
It is common here and it mostly affects how we get to the position rather than whether it exists. We work from outside where the pitch and access allow it, or through the ceiling access inside the unit. It does mean we would rather look at the property before quoting than guess from an address.
We are a few kilometres from the beach. Do we still need coastal fittings?
The salt load is lower here than on the beachfront, so corrosion is slower, but the wind is not lower and it is the wind that does the damage in Parklands. We seal connections properly everywhere as a matter of course, and we put the extra attention into the fixings rather than into corrosion resistance.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za