West Coast & Blaauwberg · Milnerton

DStv installation, realignment and repairs in Milnerton

Milnerton sits between Table Bay and the lagoon, which means salt on the wind from one side and steady damp from the other. Most of what we do here is realignment after a hard winter and sealing work on installations that have been up a long time.

Weathered satellite dish and cable on the wall of an older Milnerton house

Milnerton has a longer history of satellite installations than the suburbs further up the coast, and it shows in the work. A good share of the systems here went up years ago on houses that have since changed hands two or three times. Nobody has been near the dish in all that time, which is fine until the winter it stops being fine.

What we find on a system nobody has serviced

The pattern in an older Milnerton system is consistent enough that we can usually predict it before getting a ladder out. The dish itself is normally sound, because a reflector is a shaped piece of steel and age alone does not stop it working. What has gone is everything smaller.

  • Connectors that were taped rather than properly sealed, with the tape long since unwound
  • Cable that has gone pale and chalky in the sun, with the outer sheath split somewhere along the run
  • Fixings and clamps that have corroded to the point where the adjusters will not move
  • A wall entry that was never sealed, which lets damp into the wall as well as into the connection
  • An LNB that has been on the arm for a decade with its connector face open to the weather

None of that is dramatic and none of it announces itself. It shows up as a system that used to shrug off weather and now does not. Our page on cabling and TV points covers what a properly made and sealed connection involves, which is the bulk of this work.

Lagoon damp asks a different question from sea salt

Salt off Table Bay is the corrosive part: it gets under an unsealed joint, works on the braid and the centre conductor, and leaves you with a system that loses a little more signal every year. That is the coastal half of Milnerton, and it behaves much as it does in Table View further north.

Near the lagoon the problem is persistence rather than aggression. Air that stays damp for long stretches keeps moisture in every place moisture can sit: inside a connector body, in the wall entry, in the gap between a bracket and the wall behind it. It corrodes more slowly than salt but it never really dries out, and it is very good at finding a joint that was sealed in a hurry. Where a connection corrodes far enough to short, the decoder can show the LNB overload codes E74 and E75, which point at the cable and its connectors rather than at the LNB.

The wall entry deserves a particular mention on this side of Milnerton. An unsealed hole with a cable through it takes water into the wall as well as into the connection, and the damp patch that turns up on the inside of a lounge wall is occasionally our fault rather than the plumbing's. It is quick to seal properly and awkward to put right once the plaster has gone.

Realigning after a winter of wind

Wind off the bay works on the clamps of a dish season after season, and an installation that has been up for years is usually sitting on fixings that have given up a fraction at a time. The result is a dish that has drifted without ever looking as though it has moved.

We check the mounting before we touch the aim, because aiming a dish on a bracket that moves is work you pay for twice. Where the fixings are sound, a realignment is a short job. Where they are not, the honest answer is a remount first. Dish alignment explains how the two are told apart, and signal problems covers what the E48 codes mean when the picture has gone entirely rather than merely faded.

The other thing we find inside older Milnerton houses is history: a splitter fitted in a cupboard years ago to feed a second television, a length of cable joined mid-run behind a wall unit, a wall plate that was replaced by somebody who was in a hurry. Each of those is a joint, and every joint is somewhere signal can be lost. When a system has been added to repeatedly over two decades, the fault is as likely to be indoors as on the roof, which is why we test from the decoder outwards rather than starting at the dish. DStv repairs covers how that fault-finding runs.

Three kinds of building, three kinds of job

Milnerton is mixed in a way that Parklands and Century City are not, so there is no standard job here. On an older freestanding house the work is the dish, the mounting and the cable, and the decisions are ours and yours. In a newer complex or a block near the water, the wall, the roof and often the balcony are common property and the scheme decides what may be fitted, which our page on DStv in complexes and apartments works through.

There is also a fair amount of redundant equipment in Milnerton: dishes left on walls by previous owners, cabling to rooms nobody uses now. It is often worth keeping. A dish pointing north-east can be reused rather than replaced, which matters if you are considering OpenView instead of a subscription service, since OpenView is free to air with no monthly fee once you own the equipment. See OpenView installation in Milnerton if that is the direction you are going.

Questions we get asked in Milnerton

Our house backs onto the lagoon rather than the sea. What should we expect to fail first?
The connections, same as on the coast, but more slowly and for a different reason. Constant damp keeps moisture inside a connector body and in the wall entry where it cannot dry out. It is a sealing problem rather than a salt problem, and it is fixed the same way: cut back to clean cable, remake the joints, seal them and add a drip loop.
The signal has got a little worse every winter for three years. What is that?
That gradual pattern is either a mounting drifting under wind or a connection corroding, and often both at once. What it is not is a decoder fault, because a decoder does not degrade by degrees. We check the mount and the joints before assuming anything needs replacing.
While somebody is up there, is it worth replacing the LNB anyway?
It depends on what it looks like. If the housing seal has perished or the connector face is corroded, replace it while the technician is on the roof rather than paying for a second visit in a year. If it is sound, a working LNB is not something to swap for its own sake, and we will say so.
A storm knocked the picture out. Should we wait to see if it comes back?
Give it a little time, because weather-related signal loss does return on its own once the front has passed. What should not happen is the picture failing to come back at all, or coming back weaker than before. That means the storm moved something or opened a joint, and it will not repair itself.
Is it worth resealing connections while the picture is still fine?
On an installation that is a decade old on this coast, yes. Resealing is a small job while the cable is still sound and a much larger one once damp has got into the run and the connector faces are corroded. It is the cheapest thing you can do to an ageing system.
We are in a newer complex near the water. Is the job different from a house?
The technical work is the same. What changes is that the wall, the roof and usually the balcony are common property, so the body corporate decides what may be fitted and where. Establish whether the building already runs a communal system before arranging anything, because that often answers the question for you.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za