Southern Suburbs · Retreat

DStv repairs and installation in Retreat

A lot of Retreat installations went up long ago and have never been touched since. Most are worth putting right rather than replacing, but it takes testing the run to know which parts are still doing their job.

Installer's van loaded with a satellite dish, ladder and tools

Retreat has a lot of long-held houses — freestanding homes, semis and older council-era stock — and satellite installations that came with them. When we are called out here, the system on the wall is often older than the decoder inside, and nobody in the house knows who put it up.

Installations that have been on the wall for decades

An old installation is not automatically a bad one. Some of what we find was done properly and has simply weathered: the dish is sound, the mount is solid, and what has failed is the last half metre of cable and the connector on the end of it. Some of it was marginal on the day it went in and has been getting worse ever since.

The way to tell the two apart is to test rather than to look. We check the mount for movement, the run for continuity and shorts, and the connectors for water, then say which parts are worth keeping. A dish that is fifteen years old and undented is usually a keeper; the cable of the same age very often is not.

The older council-era houses have their own pattern. The roofs are small and simple, so the dish has often ended up on a gable, a short pole or a boundary structure rather than on a broad wall, and over the years more than one household may have added to the same run. Where that has happened we trace and label what is there before touching it, so that fixing one point does not take out another.

Cable that has done its time

Cable ages faster than anything else on the outside of the house. Sheathing on the sun-facing elevation goes chalky and then splits, staples driven too hard flatten a run and change how it carries signal, and rodents in a ceiling do what rodents do. None of that is visible from inside, and all of it produces the same complaint: a picture that used to be fine and now is not.

Where the rest of the run tests sound we replace the section that has failed; where it does not, the run is replaced properly rather than patched twice. Cabling and TV points explains what the testing looks for, and DStv repairs covers the rest of the fault-finding.

The wall points are the other survivor from that era. Plenty of Retreat lounges still have coax that was put in for an analogue aerial, terminated at a plate that has been painted over twice. Some of it will carry a satellite feed perfectly well and some of it will not, and the only way to know is to test it rather than to trust that it is already there.

Wind off the bay on an inland roof

Retreat is not on the coast, but it is close enough to False Bay that the wind arrives with something in it. Over a decade that reaches galvanised fixings, bracket bolts and any connector that was not sealed, which is why fittings here give up earlier than they do on the same house design further north. It is a slower version of what we deal with in Muizenberg rather than the same thing, but it belongs on the same list of causes.

The practical consequence is the order of work. A realignment on an old Retreat installation starts with the mount, because aiming a dish that sits on a bracket which moves puts it right only until the next front. Dish alignment goes through why that sequence matters more than the aiming itself.

Deciding what to keep and what to replace

On an ageing system we work through the parts in order of how likely each is to be reusable, and we tell you what we are keeping before we start rather than presenting a list of new hardware afterwards.

PartUsuallyReplaced when
DishKeptIt is dented or distorted, or the mount has corroded past being safe
LNBAssessedIt is failing progressively, or a wet connector has shorted it
ConnectorsReplacedEvery joint we open, without exception
CableTestedThe run reads badly, or the sheathing has split along its length
Wall plate and flexKeptThe plate is loose in the wall or the flex has been pulled about

Households running a second television without wanting another monthly cost sometimes go free-to-air on that set. OpenView carries no monthly subscription fee and works off a dish pointing north-east, which is very often exactly what an old Retreat installation already has on the wall — OpenView in Retreat covers reusing one.

What helps when you phone about an old installation

Two things save time on an ageing system: roughly when the picture started changing, and whether it fails in wind, in rain, or in all weather equally. Neither needs you to go near a ladder, and between them they usually point at either the mount, the connectors or the cable before we arrive.

Questions we get asked in Retreat

The installation came with the house and we have no idea how old it is. Where do you start?
At the wall point, working outwards. We establish what the run is delivering, whether the mount is still solid and whether water has got into the connectors, and that usually identifies the fault without anything being replaced on spec. Age on its own tells us very little.
Do you replace the whole cable run or only the bad section?
Whichever the testing supports. If the rest of the run reads well, replacing the failed section and remaking the connectors is a sound repair. If the sheathing has gone along its length or the run has been damaged in several places, replacing it once is better than being called back to patch it again.
The wall plate is loose and the picture flickers. Are those connected?
Very likely. A loose plate means the termination behind it is taking strain every time the flex is moved, and an intermittent picture that responds to somebody walking past the unit is a classic sign of it. It is a small repair, and worth doing before the connection destroys itself.
The dish looks rusty from the ground. Does rust actually stop it working?
Surface rust on the reflector does not. What matters is the mount and the fittings: a bracket rusted at the fixings will move, and a corroded connector will let water in. We check those two before deciding anything about the dish itself.
We have an old decoder and a new television. Should the installation change?
The satellite side does not care what the television is, so an old decoder feeding a new set is not in itself a problem. What often needs attention is the connection between them and the wall point they share, since both are usually as old as the rest of the installation.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za