Southern Suburbs · Wynberg

DStv installation and repairs in Wynberg

Wynberg changes character within a few streets, and satellite work changes with it. A house in the upper roads and a multi-decoder set-up in the lower half are not the same job.

Installer's van carrying a satellite dish, ladder and tools

Wynberg is large enough that two jobs a few streets apart have almost nothing in common. The main road is the dividing line. Above it the houses are older and stand in their own gardens, with trees that have had decades to grow into a line of sight. Below it the plots are smaller, there are flats and semis, and more households run more than one decoder off a single dish.

One suburb, two kinds of satellite job

It is worth saying which side you are on when you book, because it changes what the job needs before anyone climbs anything. Conditions are sheltered and inland on both sides, with none of the salt exposure we work around in Muizenberg, so faults here are mechanical and cable-related far more often than they are corrosion.

That also means an installation in Wynberg can last a very long time if it was mounted and cabled properly. Most of what we are called to is not worn out. It is a system that was added to over the years without anybody checking what the original run could still carry.

Above the main road: older houses and mature trees

The upper streets were built long before anyone needed a clear view to the north-east, and the obvious wall is frequently the wrong one. The dish has to see that part of the sky past a gable, an oak or a neighbour's tree line, and on a deep plot with established planting that can rule out three positions before we find a fourth.

Growth is the slow version of the same problem. A tree that sat well below the dish when the system went in is now level with it, and the picture has been getting worse for a couple of seasons without anything at the house changing. Aiming a dish that is already pointing correctly into a branch achieves nothing, which is why we check the path before touching the bracket — dish alignment covers telling drift from obstruction.

  • A position with a clear north-east view that will still be clear after a few more years of growth
  • A wall or gable that can carry the load, rather than the most convenient piece of plaster
  • A cable route that keeps the run out of the sun and off the edge of a gutter
  • An entry point into the house that suits where the decoder is actually going to stand

Below the main road: shared feeds and several decoders

In the lower half the questions are about distribution rather than position. How many rooms does the signal have to reach, what is already in the walls, and is the dish on the outside of the building yours or the building's?

A second decoder linked to the first is XtraView, and it needs a feed to the second room that the original installation may never have been built to carry. Three or more rooms is a whole-house exercise rather than a series of add-ons, and that is multiroom installation.

In a freestanding house, a Smart LNB is what MultiChoice recommends for an Explora and for most XtraView installations, and it carries multiple signals down a single cable instead of a new coax run down the wall for every decoder. In a block the answer is different: DStv states plainly that the Smart LNB is not suitable for multiple unit dwellings, so a flat below the main road belongs on complexes and apartments instead.

Faults that come from how a system was extended

A large share of Wynberg call-outs are not failed hardware at all. They are installations that were extended once, then extended again, with a splitter added each time and nothing tested afterwards. The picture holds up in fine weather and gives up in the first proper front, and the point that fails first is the one at the end of the longest run.

That is measurable rather than a matter of opinion. We test what the existing run is delivering before adding anything to it, and we say so if the installation is already at its limit. Cabling and TV points explains what that testing looks for, and signal problems covers what the codes on screen are actually telling you.

When nobody is sure whose dish it is

Divided properties, converted houses and small blocks all produce the same situation: a dish on an outside wall belonging to somebody who may have moved out years ago, feeding cables nobody has ever labelled. Cutting into that to fix one household creates two faults instead of one.

We trace and label the runs before changing anything on a shared installation. It is unglamorous work and it settles the argument in advance rather than afterwards.

If it is the subscription you are reconsidering, not the equipment

OpenView is free-to-air with no monthly subscription fee, and it works off a dish pointing north-east — so a redundant DStv dish on a Wynberg house can often be reused rather than replaced. OpenView in Wynberg covers what that takes.

Questions we get asked in Wynberg

The system was fine until a point was added for the back room. What happened?
Adding a point divides what the installation is delivering, and if it was already near its limit, every point ends up weaker. That shows as the furthest room breaking up in poor weather while the lounge carries on. We measure what the run is actually delivering and say whether the equipment at the dish end has to change before another point is added.
We have a cottage in the back yard. Can it run off the house's dish?
Usually yes. One dish can feed more than one decoder, and a second dish on the same property is rarely necessary. What it needs is a feed of its own and a decision about whether that decoder is linked to the house's or runs on its own, because that changes what goes in at the dish end.
Nobody left us any paperwork when we moved in. Can you tell what we are connected to?
Yes. We trace back from the wall point and establish whether you are on your own dish or a shared feed, and where the run goes. In the lower half of Wynberg that is a common first step, and it is worth doing before anyone pays for parts.
Our dish is on the front wall and the house is being painted. Should it come down?
It does not have to, but tell the painters not to lean anything on it. A ladder against the arm is one of the most reliable ways to knock a dish out of aim, and the picture will usually seem fine for a week or two afterwards before it starts breaking up.
The flat above ours has a dish on the same wall. Can that interfere with our signal?
Not by being there. Two dishes on one wall do not interfere with each other. What does cause trouble is shared or crossed cabling, and a short in a cable or connector can produce DStv's LNB overload codes, E74 and E75, on a decoder that is otherwise healthy.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za