Northern Suburbs · Kraaifontein

DStv installation and repairs in Kraaifontein

Kraaifontein covers a lot of ground and a wide range of housing, but two jobs account for most of what we do here: putting an installation in, and straightening one out after the wind has been at it.

Satellite cable clipped neatly along an exterior wall towards a wall point

The suburb runs from compact older plots to developments finished in the last few years, with simple single-storey roof access over most of it and clear sight lines in most streets. What it also has is heat in summer and a great deal of wind, and both are felt by the half of the installation that lives outside. Neither of those is a difficult suburb to work in. What decides whether an installation here lasts is the detail at the two ends of the cable rather than anything clever in between.

Cabling a finished house that has nothing in the walls

Plenty of installations here start with no cable at all. On a single-storey house with an accessible roof space, that is the good version of the problem: the run crosses the roof, drops inside a wall and comes out at a plate, and nothing is visible in the room except the plate itself. On a house with a flat roof or a slab there is no void to use, so the route follows a bulkhead, the inside of a cupboard, or an external line the eye already accepts.

We show you the route before drilling anything, and where the tidiest route is not the quickest one to install, that is your decision rather than ours to make quietly. Cabling and TV points covers the standard we work to, and multiroom installation covers planning several points in one go rather than one a year.

The calls that follow a windy week

After a hard blow the phone brings a particular kind of call: a picture that was fine last month, is patchy now, and is at its worst in the afternoon. That is a mounting and aim question rather than a parts question, and the two get dealt with together, because there is no sense aiming a dish that sits on a bracket which moves - it will be out again by the next front.

It is worth being straight about what a realignment cannot do. If something has grown or been built into the line of sight, aiming the dish from the same position achieves nothing and the dish has to move instead. If a connector is full of water, the symptoms look identical and the aim is innocent. Dish alignment and signal problems between them cover how those get told apart before anybody gets on a ladder.

What a summer of heat does outside

Wind gets the blame for most of what goes wrong out here, but heat does its own quiet damage. Everything on an exterior wall expands through the day and contracts overnight, every day, for years. A connector that was hand-tight rather than properly made off works itself loose on that cycle alone, and a cable clipped drum-tight with no slack in it puts the strain on its ends instead of on the run.

It shows up as a fault that follows the clock rather than the weather: fine in the morning, unreliable by mid-afternoon, back to normal after dark. That is a genuinely useful thing to tell us on the phone, because it points at a different set of suspects from a fault that only appears in wind or rain. Cable and trunking on a sun-facing wall also go brittle faster than the same run on a shaded elevation, which is why we would rather route down the shaded side where there is a choice.

Two or three decoders on one dish

Multi-decoder households are the norm here rather than the exception, and what that asks of an installation is more than an extra length of cable. Each decoder needs its own feed, and how many feeds are available is decided at the dish. On a freestanding house MultiChoice recommends the DStv Smart LNB for DStv Explora and most XtraView installations, describing it as combining the features of a DStv Switch into a single UniCable LNB for distributing multiple satellite signals over one cable. In a complex that recommendation does not apply, because MultiChoice states it is not suitable for multiple unit dwellings.

OpenView comes up in this conversation a lot, and fairly. For a second or third set, a free-to-air service with no monthly subscription is a reasonable answer: the OV512 decoder, over 20 TV and radio channels including SABC channels and e.tv, and a dish pointing north-east, which means an existing dish can often be reused rather than replaced. OpenView installation in Kraaifontein covers it, and XtraView installation covers the DStv route to a second room.

Worth knowing before we quote a second point

Three things change the answer, and you can check all of them from inside the house.

  • How many decoders the installation already feeds
  • Whether there is a usable roof space above the room you want the point in
  • Whether the existing points all still work, or only some of them
  • Where the television will actually stand once the room is finished

Questions we get asked in Kraaifontein

Nothing was run for satellite when the house was built. How does the cable get in?
Through the roof space and down inside a wall where there is a usable void, which leaves nothing visible but the wall plate. Where there is no void, the run follows a bulkhead, a cupboard or a tidy external line. We agree the route with you before anything is drilled.
How do you decide whether we need a realignment or a repair?
By the pattern. A picture that faded over months, or that fails in wind and recovers afterwards, points at the mounting and the aim. One that died overnight points at a part or a cable. We ask a few questions on the phone and check both on site, because the two arrive together more often than not.
Does a second decoder mean a second subscription?
The subscription side sits between you and DStv rather than with us. What we deal with is the installation, and a second decoder needs its own feed from the dish, its own cable and its own point. Whether the system as it stands can carry that is what we check.
What do we need to get OpenView working?
An OV512 decoder and a dish pointing north-east. Where there is already a dish on the house in reasonable condition it can often be reused, which leaves the decoder and the connection work. There is no monthly subscription on the service itself.
Can the dish and a new point be done on the same visit?
Usually, if we know about both when you book. Remounting or realigning a dish and running a new point use different tools and different parts of the day, so it is the sort of thing that goes wrong when it is sprung on the technician after he has arrived.

Get it sorted

Book a technician

Tell us the make, the size and what the screen or decoder is doing. We will give you a time slot and a quote before anyone starts work.

218 Thornton Road
Thornton, Cape Town
info@capetvrepairs.co.za